Header Only - DO NOT REMOVE - Extreme Networks

2016-11-28: New GTAC Knowledge Articles November 20 - 26, 2016

Here are the new articles that were published November 20 - November 26, 2016 in GTAC Knowledge:

Sunday, November 20, 2016:

Monday, November 21, 2016:
LLDP/EDP Links between some devices are not seen in Maps
How to avoid keyboard record when capture logs from EXOS device
Does EXOS support exclude ip address from a dhcp pool
Does EXOS support compare booted configuration and running configuration?
what's the different from "show log" and "show log message nvram"
What is the OID for monitor Extreme Stacking port link status
How do I continually run CLI commands in a loop?
Siem: How to configure the SMTP (mail) relay on a Siem console
i2c-octeon kernel messages
Is it possible to do SSH directly to Standby slots via alternate IP addresses?
What is the channel of power from the X440-G2 switch to POE devices

Tuesday, November 22, 2016:
With the distributed ARP mode enabled, L3 routed packets get dropped on egress LAG ports
What is the Securestack MIBs to monitor power supply?
Where is the Extreme Development Fund (EDF) Tool and Not For Resale (NFR) Form?
How to remove private AS Numberl from BGP route updates?
S series with bonding and VRRP may not return to recover from loss of master
How to configure Active/Standby port or LAG feature in EXOS
after creating a VLAN starting with "vr" the output of "show iproute vr vr-mgmt"
show vid output shows flag status incorrectly
Where Can I Find the EXOS Stacking Tool?
NAC rejecting all 802.1x authentications with Access denied (0xc0000022)
How to limit the bgp maximum as path length?
How to enable Bidirectional Forwarding Detection (BFD) protection of BGP peering sessions
What is the BGP Route Selection rule on EXOS product?
What are the console settings for PV-FC-180?

Wednesday, November 23, 2016:
Siem: Newly added flow collector not sending flows to flow processor
S-Series Fabric and I/O Module Compatibility
S series Reboot caused by Deleting VRF results in DSI Thread Name: tVrrpRX
Netsight: How to set the time and/or date on a switch through netsight

Thursday, November 24, 2016:
Is that possible to use the same VRRP routing instance for ipv4 and ipv6 in a switch.
AP default password warning pop-up was introduced with V10.11.04
AP3705 crashes without a crash dump
what types of logs will be cleared from the switch after a reboot

Friday, November 25, 2016:
WLC711 Controller - Radio [2] on 2.4Ghz turned off due to incompatible antenna selection with ANT792-6MN
Why is the time on my AP different to the time on the controller?

Saturday, November 26, 2016:
BGP route not advertised when the source interface IP address is same as next hop address

1 reply

Userlevel 6
Every week we get a flood of feedback after Ken posts his list. Thank you and keep it coming.

We act on every improvement suggestions you give us and publish back out immediately. This feedback loop with our users is a crucial element of our knowledge program. I'm confident you see this, which is why get the feedback in the first place. Good stuff.

We're also working on an improved KB home page so these new content announcements are automated, personalized and dynamic. More to come on that in the future.