2016-12-19: New GTAC Knowledge Articles December 11 - 17, 2016

Here are the new articles that were published December 11 - December 17, 2016 in GTAC Knowledge:

Sunday, December 11, 2016:
Why some third party devices complain about OSPF checksum error with EXOS switches?

Monday, December 12, 2016:
WS-AP3825I - Intermittent connections are still seen after 9.21.12 upgrade
Can Installed License be Recovered if Securestack is Cleared to Factory Defaults for Re-deployment Elsewhere in Network?
Securestack Cannot Ping One Remote Subnet Due to New Device connected on Directly Connected Subnet
Fuji 1 Host Rx0/Rx1 CRC error check failed on Fabric Module on K-series
How to troubleshoot a client (MU) that fails to get an IP address or has an APIPA IP address (
Flapping of the fabric ports causing impact to traffic in the module with error message "MSM-A: Sys-Health-Check: Switch fabric port state is Down for Module in MSM-A"

Tuesday, December 13, 2016:
How to configure "Provider-Bridge" (Q-in-Q) on a S-Series
Where can user see AP's MAC and IP addresses in OneView
After the upgrade to 10.01.xx, Chromebook users could not attach to the AP37xx series, but are able to connect to the AP39xx series.
How to Perform a Packet Capture on Summit WM3000 and RFS Series Controllers
Wireless AP3935 session poll disconnect, Wireless AP session timed out
Cisco IP-Phone 7925G on IdentiFi Wireless lose calls or hanging up call and need to redial again
How do I reset Matrix E1 to factory defaults?
How to contact Zebra's support team for Brazil?

Wednesday, December 14, 2016:
AP3825 reboots after 9.21.11 upgrade, watchdog exception, raw_spin_lock
Is it Possible to Transfer (Rehost) EXOS Licenses From one Switch to Another?
Dropbear Vulnerability detected on Security Scan
S-Series Stops Sending Netflow Records to Purview
Can I use "source-address" as a match condition in a Routing Policy
Error: Timeout: Download on remote slot (s) failed, aborting download
CiscoDP IP Phone cannot MAC auth after firmware upgrade on SecureStack B5
Endsystems failed MAC Authentication on SecureStack A4
Where did all the client reports go to after I upgraded to 10.21 firmware
Can the DHCP binding to storage file configuration in the switch be removed?

Thursday, December 15, 2016:
Wireless connectivity is down since firmware upgrade to 10.11.01.
Surface Pro clients unable to get an IP address from their DHCP server, connections drop off at random intervals.
AP3805 reboots after 9.21.11 upgrade attempt
Can modules of the previous generation like the XGM3-2SF be used in the Summit X460-G2?
K-Series : Unit locks up and needs reset - Faultlog reports Petra[1] exceeded maximum soft resets
AP radio stuck in scanning mode after using multi-edit to set channel on the AP radio

Friday, December 16, 2016:
Are there SNMP values that can be polled to capture the FDB tables size, IPARP stats, IProute counts

Saturday, December 17, 2016:

2 replies

Userlevel 7
Hey Ken, thx for the update !!!
very welcome, Ron - happy holidays!