Header Only - DO NOT REMOVE - Extreme Networks

2017-07-24: New GTAC Knowledge Articles July 16 - 22, 2017


Here are the new articles that were published July 16 - July 22, 2017 in GTAC Knowledge:

Sunday, July 16, 2017:
none

Monday, July 17, 2017:
How to clear the configuration on a 200 Series switch
How to configure serial timeout on 200-Series
How to configure an Indentifi Wireless Controller to send data to an Analytics appliance using firmware 10.21.02 or higher and setting up Extreme Management Center to receive it.
WiNG Client Bridge will not stay online
Not seeing port names in NetSight Compass search for XOS
Are WiNG APs adopted over the wireless network by default?
Error logs "CFP2 modules >= 18 W unsupported" appears for Finisar Corp CFP2 LR4
Does AirDefense require a license to view heat maps of APs?
wl2 phones disconnected from the wireless network when an iphone7 is in the vicinity

Tuesday, July 18, 2017:
How to configure IP Helper on ExtremeSwitching 200 Series
SNMP Error: No such name is reported in logs
Can I configure more than one IPFIX collector on XOS device
Location of Mibs for 200 series
Where are the demokit files in the new portal?

Wednesday, July 19, 2017:
Error message: getting broadcast address: Cannot assign requested address
A4-Series Shows Installed and Operating for Unused PS2-RPS source
Updated to Java 8 1.41 and unable to launch NetSight Java applications
Service & Support FAQ – Avaya Integration
Extreme Control Appliance red after upgrade to 8.x
Unable to enforce Analytics Appliance
EMC Software won't run with INSTALLER FAILED message
EMC: Load Configuration Utility in Discovered devices is grey out
How to add license key in EMC 8.x

Thursday, July 20, 2017:
Does FCoE implementation on EXOS switches runs at 16 Gbps?
How to physically locate an AP using the LED flash sequence
AP3935 access points downgrades from 10.21.01
EXOS X440-G2 not disabling all required netlogin traps

Friday, July 21, 2017:
AirDefense Services Platform ADSP V9.1.3 21 encounters burst of Hunter killer tool Alarms and becomes inactive
How to disable and recreate a non-working cluster on WiNG controllers
Is it Possible to Encrypt the L2-GRE or VXLAN L2 traffic with MACSEC?
HP laptops showing a limited or no connectivity status after after upgrade to 10.31.
How to default cluster setting on a WiNG controller from CLI
Your change could not be saved due to an internal error
Error updating table /var/controller/data/db/lefloors.bin id -1

Saturday, July 22, 2017:
none

0 replies

Be the first to reply!

Reply