Header Only - DO NOT REMOVE - Extreme Networks

2017-10-31: New GTAC Knowledge Articles October 22 - 28, 2017

  • 31 October 2017
  • 0 replies

Here are the new articles that were published October 22 - October 28, 2017 in GTAC Knowledge:

Sunday, October 22, 2017:

Monday, October 23, 2017:
No End systems are showing up in Reports for Extreme Access Control / NAC devices
Client is connected to 802.1X network but performance is very low
How to configure MAC Authentication Bypass on 200-Series switches
Nintendo 3DS will not connect to SSID
Android captive portal detector doesn't pop on connection to EAC controlled SSID
WEB-GUI doen't accept semicolon in SNMP sysLocation and sysContact
How to restrict the switch to only send OSPF Adjacency State Change Traps

Tuesday, October 24, 2017:
Why I cannot add more CPUs to ADSP virtual machine?
Missing "Check Point" connect module
How to verify DHCP lease on WiNG device?
Why Chromecast is blocked by a Wing AP?
Why domain enrolled device cannot access Captive Portal pages?
sometimes slow startup extreme switch due to a restart of the OSPF process
High CPU on S-Series - SNMP
Changing TFTP Root directory in Extreme Management Center is not updating nstftpd.cfg
Incorrect output power on Summit G2 PoE Switches

Wednesday, October 25, 2017:
K-Series - Rebooting with 'Thread Name: tSsh "
Analytics appliance unable to contact the server after the server was upgraded to
How to find a rogue client on wireless network
How to configure a new or replace an existing default gateway IP on a WiNG virtual controller from CLI
Connecting Many-to-One Mirror to a Mirror Source on S-Series Causes High CPU Utilization
What is the difference between AP firmware LEAN image vs standard image?
How to redirect DHCP/bootp traffic to NAC in EXOS
PoE does not work
Wildcard Certificate for Guest Portal doesn´t work correctly if using HA mode
How to use MAC authentication bypass on WING

Thursday, October 26, 2017:
NAC appliance unable to contact the server after upgrade to
After 10.41 upgrade ACS may run and channels and width may be changed
Access Point (AP) ERROR: Problem with diag image, dropping to interactive shell
Why is there no VLAN name displayed in NetSight Compass for XOS switches?
emc: Procedure to Change a Switch Port Alias
Does WiNG support QoS?

Friday, October 27, 2017:
sFlow support for LAG(s)
How to factory AirDefense M520 sensor?
Bootprelay doesn't work on ports 25-48 on non-Master X440-G2-48p/t in a SummitStack.
What types of licenses are used in WiNG?
How to remove license from WiNG device?
How to configure DHCP service using GUI on WiNG device?

Saturday, October 28, 2017:
Applying ACL on EAPS master secondary port causes network loop

0 replies

Be the first to reply!