Header Only - DO NOT REMOVE - Extreme Networks

2017-11-27: New GTAC Knowledge Articles November 12 - 25, 2017

  • 27 November 2017
  • 0 replies

Here are the new articles that were published November 12 - November 25, 2017 in GTAC Knowledge:

Sunday, November 12, 2017:
How to configure switch for Phone + Data using Extreme Access Control

Monday, November 13, 2017:
How many ESRP slaves does EXOS support?
Issue with reports not loading in ExtremeManagement; ExtremeWireless GUI slow to respond to Report Generation or configuration updates.
How to Install Extreme Management Center 8.0
How to Change the Name of an Access Point
How to disconnect client from WLAN via CLI?
Is there a Mib for the Show Fdb Command?
How to create new Web Portal Account
NAC Active Authenticated End-System report is incorrect after NAC process restart /sbin/nacctl restart

Tuesday, November 14, 2017:
Will an S4 db9 to rj45 cable work on an Exos device?
Where are the Admin Web Page Credentials for Extreme Control (NAC)
After Upgrading to 10.41.01 code AP3825 started crashing
Firmware upgrade fails on EXOS switches when using SCP and Extreme Management Center
How to recreate a RAID disk on NX9500/NX9600
With alternate IP configured, MLAG ports may be disabled momentarily when other MLAG peer comes Up after reboot
What does LED blinking means on AP650?
SNMP Object "extremePowerSupplyTable" not available in
WING: how to setup rate limit per Wireless LAN
WING: How to setup rate limit per wireless client
What is Elastic Storage feature?
Is there an option to specify source IP in TFTP command
NAC doesn't write RADIUS configuration on enforce for switch

Wednesday, November 15, 2017:
How To Configure BGP Multihop on S-Series
How to disable the DOSATTACK: IPSPOOF ATTACK message on a WiNG AP
How to configure a secondary IP address on routed interface for Modular EOS Routers
Design Considerations when using EXOS MLAG to connect to EOS stp enabled switches
S-Series : After rebooting the switch the "ip ospf network point-to-point" command is missing from the config for non default VRFs
AP622 failed to broadcast SSID after upgrading to
How to install and use an IA-ES key on your Extreme Access Control appliances
800-Series : Not passing traffic intermittently

Thursday, November 16, 2017:
Clients are presented with the Portal Splash page upon roaming to another Access Point in an Extreme Cloud Wireless network
After roaming between two APs in the Extreme Cloud Wireless network, the end client devices are presented with an untrusted certificate pop-up page.
How to Unconfigure Rate-Limit of a Port of an EXOS Switch
B/C/G-Series attempt to create L3 Interface results in "Could not Create Vlan Interface" error
Port is link down unexpectedly
How to Gather serial number information from devices in Extreme Management Center
How to Clear a Unit In SecureStack Showing Not Present
How to enable SSH on a 200 Series switch
Packets that ingresses particular MLAG port is not egressing another MLAG port.
How to Check for Extreme Management Center Updates
Links between EXOS and EOS switches are missing in EMC
Airflow Requirements for Black Diamond 8000 series switch

Friday, November 17, 2017:
Purview - can reports be created against specific APs
What is the Difference Between K-AC-PS and K-AC-PS-1400W?
How to configure OSPF routes to be protected by BFD?

Saturday, November 18, 2017:
How to send port display string in SNMP inform packet

Sunday, November 19, 2017:

Monday, November 20, 2017:
10 Gig Connection on C5K not working
With SSH enabled in EXOS, client displays "no matching key exchange method found. Their offer: diffie-hellman-group1-sha1"
Multicast Streams Getting Dropped on ExtremeSwitching 200 Series
Kernel crash occurs when processing a IGMP packet with an invalid IP header length
After ESRP failover L2VPN session remain in signaling state with ESRP VPLS redundancy enabled

Tuesday, November 21, 2017:
Brocade Support Integration End User FAQ
IdentiFi Controller with error message "Apply product key failed: Permanent license is not allowed."
Where are custom FlexView files saved on server?
How to Connect the Antenna DQ04360N to an AP3965e
S-Series Displays Conflicting HAU Output between "Show Config Boot" and "Show Boot High"
Two AP3620 Access Points in a WDS setup are performing poorly, and much lower Rx and Tx rates than similar WDS/Mesh configurations in the same network.
Why AirDefense Mobile cannot connect to ADSP?
How to Set Webview to Use SSL on SecureStack
How to Disable Telnet and Enable SSH on Securestack
Why controller is not adopting APs with message "cfgd is unable to adopt"?
Is it possible to check, from the WING-infrastructure side, if a client supports the higher IEEE channels (UNII-2, UNII-2-EXT, UNII-3/ISM)?
Does EXOS flush FDBs in protected VLANs if additional protected VLAN is added to EAPS domain?
High CPU utilization in the switch after re-creating an existing sharing group

Wednesday, November 22, 2017:
What does a port status of "Dormant" indicate?
Memory leak in process policy
AP2610/20 Enterasys Siemens serial numbers
Is is possible to enable LLDP on the management port?
EXOS returns NAK for a Radius Disconnect Request
Communication loss between the end hosts connected via VPLS connection after adding a new port to the sharing group
Packets are not being forwarded after disabling/enabling LAG ports in VPWS
MPLS RSVP-TE LSP load sharing not working

Thursday, November 23, 2017:
Equivalent Isotropic Radiated Power EIRP for the AP3965i is much lesser than for AP3865e
Given key is not a valid encrypted key. Please provide a valid encrypted key that is encrypted by the switch.

Friday, November 24, 2017:
Why do we get the following message in the ISW switches - The uploaded firmware image is invalid. Please use a correct firmware image

Saturday, November 25, 2017:

0 replies

Be the first to reply!