Question

How do you reinstall an IOS onto a HP 4/8 san switch / Brocade 200E ?


i have 2 switches both with no iOS and they repeat

The system is coming up, please wait...Read board ID of 0x80 from addr 0x23
Read extended model ID of 0x19 from addr 0x22
Matched board/model ID to platform index 6

Read board ID of 0x80 from addr 0x23
Read extended model ID of 0x19 from addr 0x22
Matched board/model ID to platform index 6
Failed to Identify the drive
Checking system RAM - press any key to stop test

Checking memory address: 00100000

System RAM test using Default POST RAM Test succeeded.

Press escape within 4 seconds to enter boot interface.
Booting "Fabric Operating System" image.
Resetting ATA controller.
ATA controller reset failed.
Read map file failedd
Booting "Fabric Operating System" image.
Resetting ATA controller.

Also i am unable to find a iOS. I dont not have a Brocade or HP service plan so i know they wont be of any help at all. i need a step by step procedure on how to install an IOS

2 replies

Userlevel 4
Do you have any Extreme devices?
Extreme devices uses XOS, but not the IOS.
Sumit Tokle wrote:

Do you have any Extreme devices?
Extreme devices uses XOS, but not the IOS.

I was asking about a brocade 200e not a extreme networks switch

Reply