Could someone explain what the following fields within the show edp port * detail command mean?
Tx stats: sw-pdu-tx=846 vlan-pdu-tx=846
Rx stats: sw-pdu-rx=875 vlan-pdu-rx=0
Specifically the VLAN PDUs. Are these sent over a specific...
I looking to install Management Center as a fresh install on a Windows Server. I have not done this before. Could someone please tell me where I get the file from, which version I should be installing and which file this would be?
Any help is m...
The default configuration for ports on a x670-g2-48x appears to be with auto-neg off:
configure ports 1:14 auto off speed 10000 duplex full
I have inserted a copper SFP and tried to change to auto on. Although the command is there I get an error:
Are there any limitations on EXOS versions for Summit switches that are required for a device to be managed by Management Centre? For example, if devices are currently being managed by Netsight and we were to upgrade to Management Centre, would there...
When reading the Management Center installation guide it mentions the server requirements for small, large and enterprise installations. I assume this is referring to the number of devices being managed but there is no indication of the limitation of...
Thanks for the reply.
On the same note, I do not seem to be able to set any ports to 100M with auto-neg.
Slot-1 Core.44 # conf ports 2:33 auto on speed 100
Error: Speed specified is not supported on port 2:33.
We have some legacy devices that only ...
The customer currently have around 90 nodes consisting of Summit switches some of which are stacks of 2 or more members. Would this be covered by the Small deployment?
They currently use Netsight and I believe this runs on a Windows Server.