New Contributor III
since ‎09-07-2021

User Statistics

  • 25 Posts
  • 1 Solutions
  • 6 Kudos given
  • 1 Kudos received

User Activity

Hi All. Need some guidance here:After AP5010 is switched from XIQ to WING mode - can its MGMT CLI interface be accessed via zero config IP address by the eth0/eth1 port, or can it only be accessed via the microusb console port? Asking this because th...
Hi I encountered an issue in the below setup and any help is appreciated!- I set the Eth1 port on my Aerohive AP in WAN mode (WAN IP assigned by ISP via DHCP). It can pull an IP address (say from my ISP, and the AP can ping / trace route to ...
Curious if this AP work with any brand of routers, or does it require Extreme Networks' AP controller to manage?My current plan is to connect 3 APs to a consumer brand router and use XIQ to to manage AP's basic functions -- will this setup work? Than...
Will this AP work in standalone mode with the newly release Wing firmware? Also it seems the flash UI is no longer included so configuration can only be done through CLI? Thanks. 
Does anyone know the CLI that shows AP's actively connected client devices' (through wifi radios and also ethernet) information, including hostname, mac address, IP address ...etc ?I know the WebUI only shows connected Wireless Clients, but not those...