Data Center (VDX)
Questions and discussions about VDX
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Change Airflow and make the OS recognize the change

I changed the airflow with command chassis fan...It seems that the direction was changed, but the show bare-metal output:-- Power Supplies --PS1 is faultyPS2 is faulty-- Fan Status --Fan 1 is FaultyFan 2 is FaultyFan 3 is FaultyFan 4 is FaultyFan 5 i...

mt by New Contributor
  • 510 Views
  • 1 replies
  • 0 kudos

Resolved! Password recovery again

Good morning all, I am trying to reset a previous admins password on a vdx however they have set a boot prom password so I am unable to reset. Could anyone help with the string please?xz6WtW6po6.eIVIyKTMagg== many thanks Marc  

Marc7 by New Contributor II
  • 994 Views
  • 1 replies
  • 1 kudos

Resolved! Brocade VDX - IPv6

Hello Experts,I see below two routes v6 on the switch, I did not configure them but it's there even after wiping the config.extreme01# show ipv6 route IPv6 Routing Table for VRF "default-vrf"Total number of IPv6 routes: 2'[x/y]' denotes [preference/m...

pawarpavan by New Contributor III
  • 833 Views
  • 1 replies
  • 1 kudos

Brocade VDX 7.0.3a - PBR with IPv6

Hello Experts,Does VDX support PBR with IPv6.I have configured IPv6 standard and extended ACL , matched them in route-map then set ipv6 next-hop lastly applied route-map to the interface but traffic is not being routed as per policy. So want to confi...

pawarpavan by New Contributor III
  • 392 Views
  • 0 replies
  • 0 kudos

VDX6740 - PBR match interface Te 1/0/2(version 7.3.0)

Hello Experts,I have created the below PBR but it is not working as per expectation.Configuration :===========rbridge-id 1route-map PBR_TEST permit 10match interface te 1/0/3set ip next-hop 192.168.31.2exit ip route 10.10.10.0/24 192.168.21.10arp 192...

pawarpavan by New Contributor III
  • 678 Views
  • 1 replies
  • 0 kudos
GTM-P2G8KFN