cancel
Showing results for 
Search instead for 
Did you mean: 

Enterasys Wireless Controller: enable to switch on radio 1 on aps

Enterasys Wireless Controller: enable to switch on radio 1 on aps

Fima18
New Contributor
I have to modify a preconfigured Enterasys Wireless Controller. Each aps have radio 1 disabled and I need to switch on it on N wireless channel.
I have tried in many ways:
1) Wireless APs →Bulk Configuration → APs Default Settings → selected my AP type: here I switch on the radio 1 but I can't select Radio Mode
2) Wireless APs →Bulk Configuration → APs multi edit settings → select desired APS: here I turn on Admin mode above Radio 1 , but I can't select radio mode and after a Save the Radio 1 is always off
3) Wireless APs → APs → All → select a single AP from list → Radio 1: here I turn on Admin mode but I can't choose Radio mode, and after a Save the admin mode come back to off
4) Wireless APs →APs default settings → Common configuraton: I have turn on radio 1 and radio 2 next to my WLAN name, but I have no results.

Some ideas...
Thanks!

1 ACCEPTED SOLUTION

Gareth_Mitchell
Extreme Employee
Demo licence doesn't allow config of 5Ghz radio, it also limits channel choice on 2.4Ghz, you need to licence the product or you can put a temporary eval licence that will activate the features https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Request-IdentiFi-Wireless-Eval-lice...

View solution in original post

8 REPLIES 8

Fima18
New Contributor
Thanks Gareth Mitchell , the problem is know clear: after an upgrade the controller has lost the license (I don't know why), and after that I was unable to change the AP properties. Now I have restored the license and everything goes good.

Thank you for support!

Gareth_Mitchell
Extreme Employee
Demo licence doesn't allow config of 5Ghz radio, it also limits channel choice on 2.4Ghz, you need to licence the product or you can put a temporary eval licence that will activate the features https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-Request-IdentiFi-Wireless-Eval-lice...

Fima18
New Contributor
Thanks. In country list I can select only "Demo Country". I suspect that the controller has lost the link with licence but I'm not sure: in licence section I see "DEMO" but I have 50 Licensed APs. Can this be the reason?

Gareth_Mitchell
Extreme Employee
It is set per AP, but you can do the change with bulk settings

Per AP in the first config tab:

fca0a0e69b08485fa71d558266ec2287_RackMultipart20181120-6928-6wr6a1-country_inline.png



Bulk (Multi-edit)

fca0a0e69b08485fa71d558266ec2287_RackMultipart20181120-91827-ibpk72-country-multi_inline.png



As the GUI above says, set this first.

HTH

-Gareth

GTM-P2G8KFN