cancel
Showing results for 
Search instead for 
Did you mean: 

multiple entries for same vlan in policy manager

multiple entries for same vlan in policy manager

Seth_Bean
New Contributor III
We are attempting to create authentication by 802.1x send devices to several contain to vlan policies; we are not sure why there are multiple entries for the same vlan after adding the new vlans to the switches. We were told by the Extreme tech to run "set vlan create ##" on each switch - I don't know if that caused the multiple entries or if I did something else wrong.
2 REPLIES 2

Seth_Bean
New Contributor III
This is found in the GUI of Policy Manager, not CLI. I created the VLANs on each switch, but upon some research I believe I was given bad advise and should have added the VLANs via the Primary VLAN Model in VLAN Elements Editor.

Ronald_Dvorak
Honored Contributor
Could you post a screenshot of the CLI ouput so we'd have a better unterstanding of the issue.
GTM-P2G8KFN