cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

No DHCP fingerprints in EAC after configuring bootrely to the appliance

No DHCP fingerprints in EAC after configuring bootrely to the appliance

JohanHendrikx
Contributor II
No DHCP fingerprints in EAC after configuring bootrely to the appliance.

I configured bootprelay to my EAC appliance and noticed that there are no DHCP fingerprints. Do I have to configure something to got this working?

When I do a tcpdump i see dhcp request and other information.

Johan Hendrik System Architect Audax
11 REPLIES 11

Ryan_Yacobucci
Extreme Employee
I misread your previous comment. Not having an end system entry would point to a RADIUS problem. Good to hear you have found the problem!

JohanHendrikx
Contributor II
found problem. mismatch in radius configuration. After reconfig radius the end station show up.

Johan Hendrik System Architect Audax

Goetz__Fred
Extreme Employee
I've seen a similar Problem at customer site and here in my lab. Even after I got this in my logfile

2018-07-13 08:40:22,977 DEBUG [Match] OS match detected, MAC=00-1B-0C-96-AA-6A, IP=192.168.10.163, OS detected=Cisco IP Phone
2018-07-13 08:40:22,977 DEBUG [Match] DHCP Message details Type=REQUEST (3), Options=(1,66,6,3,15,150,35), Vendor Class Id=Cisco Systems, Inc. IP Phone CP-7906G, TTL=64

the endsystem entry in control still shows no device type and device family

f47a7e4b8e2a444cbd096432a520e2a3_RackMultipart20180713-1444-168bzor-chrome_2018-07-13_14-43-51_inline.png


I'd say both cases warrant investigation through a GTAC case.

Thanks
-Ryan
GTM-P2G8KFN