cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

All unused SFP ports on X670G2-48x is showing local-fault on link state even though it has nothing in it

All unused SFP ports on X670G2-48x is showing local-fault on link state even though it has nothing in it

Tristram_Barton
New Contributor
I have a X670G2-48x, I've been trying to add in an edge node via SFP_SR onto it and all the unused ports link state are saying local fault. They have never been used nor have had a vlan attached to them. This is only happening to the unused ports on slot 3, which is also the master.
The other ports on slot 3 that have been working before today are fine
Port: 3:18
Virtual-router: VR-Default
Type: NONE
Random Early drop: Unsupported
Admin state: Enabled with 10G full-duplex
Link State: Ready (local fault)
Link Ups: 0 Last: --
Link Downs: 0 Last: --
VLAN cfg:
STP cfg:
Protocol:
Trunking: Load sharing is not enabled.

XOS 15.7.1.4

3 REPLIES 3

davidj_cogliane
Contributor
Does it see light when you run the command I suggested above?

Do you have the same type/brand optic inserted in both ports?

I am not near my lab so can't test anything myself.

Tristram_Barton
New Contributor
I don't think so as another port on slot 1 that is unused and empty is showing a link status of Ready
Port: 1:29
Virtual-router: VR-Default
Type: NONE
Random Early drop: Unsupported
Admin state: Enabled with 10G full-duplex
Link State: Ready
Link Ups: 0 Last: --
Link Downs: 0 Last: --
VLAN cfg:
STP cfg:
Protocol:

Even if I patch a fibre the link status doesn't change.

davidj_cogliane
Contributor
I believe that just means it is not seeing any light.
Have you tried patching in fiber?
Do you know your fiber is passing light cleanly

What is the output of?
show port 3:x transceiver info
GTM-P2G8KFN