ExtremeSwitching (EXOS/Switch Engine) - Page 316 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Configuration file is not downloading in extreme switch when auto provision is enabled through dhcp

I have configured the dhcp server with option 43 code 101 with a script name "boot_file.xsf". After factory reset whenever the switch is contacting the dhcp server, it receives only ip address but not the boot_file.xsf file from the tftp server which...

OSPF and MPLS route

I have created OSPF,MPLS and VPLS in our switch. One of my core swith iproute to our remote network. i found one path ospf route to remote netowrk but the mpls show have tow path to remote netowk. You can see the below information. I really apperica...

Are there any effects at the network if i configure the MLAG LACP address later?

I want to configure the mlag lacp mac adresse in a productiv network. Are there any effects at the network? I will configure the mac of the mlag peer 1 as the mlag lacp mac address.

port security

I have several x250e switches, recently i applied port security on them and i excluded some ports from it, i have been facing some issues and i need help, some PC's which i applied the port security on them on specific ports refuse to take an ip addr...

XOS LACP Share Algorithm L2 how can I make load balance?

I have X670 Core with LAGS set up to edge using multicast traffic, but traffic is not balancing using L2 or L3. Is there an extra config needed to balance traffic?

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN