ExtremeSwitching (EXOS/Switch Engine) - Page 401 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Extreme X460 - X670 CFM | Hardware vs Software Session Type

I've configured a back to back CFM domain between an X460-48x and an X670V-48x, created the association and added the remote rmep and lmep. X670V-48x Review configuration below: create cfm domain string "Access" md-level 2 configure cfm domain "Ac...

Transit ACL on L3 routing switch

Does anyone happen to have a transit ACL on a publicly routed ExOS switch? I'm using an X440 stack as an internet gateway for a customer. I did create an access profile for all of the management profiles only permitting certain IP ranges to gain a...

Netlogin - Dot1X and Mac authentication on the same port

I have netlogin successfully working with 802.1x and MAC-based when a single device is connected. I am now trying to combine this in the form of an Avaya handset - a port is configured with Netlogin: - tagged VLAN for voice (with MAC auth) - untagge...

XOS LLDP announce management IP

Hello, is there a way in XOS to announce a IP-address non vr-mgmt/mgmt-vlan in LLDP management address? most of my customers didn't use the out-of-band management port. In this case the lldp management-address field doesn't make any sense. I funct...

ssh module not loaded, set xmod imag as primary?

set the image as primary, actually am facing an issue with ssh "module not loaded" after i have checked the switch i found xmod image not set: # sh version images Card Partition Installation Date Version Name Branch ---------...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN