ExtremeSwitching (EXOS/Switch Engine) - Page 417 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Multicast Protection

We run TV Stations throughout our network via multicast(sparse) with networks at each local router that talk to end devices. We run OSPF for communication throughout our network and we have multiple RP's that these end devices can request channels fr...

Extreme using radius JUST to authenticate, not for all command verification.

I have a ExtremeXOS version 16.2.1.6 configured. My intention ware just authenticate my users, but I realized when a user pass any command the Extreme checks the permition. Is this normal? It is possible change this behavior? If yes how? Best regards

ELRP per vlan - is that possible?

XOS firmware Port configured as trunk and have some vlans tagged ELRP in case of loop in one of the vlans, disables a link on a port Is there any way of disabling a specific vlan, on which the loop is caused, instead of disabling the port? BTW, EAS ...

IPV6 broadcast storm, on an IPV4 network

We have a number of printers that by default have IPV6 configured though not used. ( not supported by me ) These printers are also connected to an IPV4 vlan where the IP address is allocated via DHCP and routed at a distribution switch X460. Recen...

Simulate a POE "Failed" state?

We are testing some network monitoring rules, and would like to generate events/alarms when a port delivering POE transitions into the 'faulted' state. Is there a way, preferably in software, to simulate a port experiencing a POE fault state?? We wan...

Top Kudoed Authors

User

Count

28

22

17

16

16

GTM-P2G8KFN