ExtremeSwitching (EXOS/Switch Engine) - Page 463 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

add no-refresh to show ports utilization

show ports utilization is one of those commands that continually goes back and refreshes its output. Once you hit ESC the table that was output is erased from the screen. It would have been nice to see the last data. Of course, other show ports comma...

QSFP+ and QSFP 28

Hello, all! There is new switch X870 with QSFP28 ports. Would it be normal working QSFP+ in this ports? As I saw - wavelenght and formfactor the same. Also Juniper have normal compatibility in such case. Thank you!

EXOS create lag for 2 switches

I have 2 new EXOS switches (X620-16x) that are going to be used for ISCSI traffic for a Nimble SAN. I am new to EXOS and I am still learning EOS so I'm new to all of it. The Nimble device recommends that the switches are "trunked" together and that...

ospf stuck in init state

ospf v2 created on 2 BD switches for communication between BD switch and Node. Point to point works okay on one BD, but didn't work on other BD side stack its in INIT stage while on Node end its is completely down. All configuration verified and ob...

How to delete part of an OSPF command in the Config

I have a couple lines in my OSPF config that i cant seem to remove. i am trying to get rid of this: configure ospf vlan VLAN_0009 priority 0 i have tried "unconfigure" command which doesnt work. not sure what else to use.

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN