Hello everyone, I recently acquired two legacy Summit X450e-48p switches for a project. They are currently running significantly different firmware versions: Switch 1: ExtremeXOS 15.2.1.5 Switch 2: ExtremeXOS 12.4.2.17 Because these models are End-o...
Hi everyone,I followed the configuration instructions in this post, but I still can't get RSPAN to work. Can anyone help, please?https://extreme-networks.my.site.com/ExtrArticleDetail?an=000080241Here is my topology and my configurations:SW2:create m...
Hello,today I played around with the built-in packet capture of EXOS ( How To: How to perform a local packet capture on an EXOS switch | Extreme Portal (force.com) )I’m able to capture packets and open the pcap file with wireshark, but I only see the...
Hello Everyone, Lets start out by saying "I am new to using Extreme Networks Switches. To tell the truth I am a novice to Networking all together. Never used a managed switch at all. I am an Audio Engineer. We have purchased the X430-8P for a small ...
Hello, I'm wondering, is there an extreme networks equivalent to the Cisco command for show interfaces that gives you output results like this? Example: reliability 255/255, txload 36/255, rxload 8/255 Thank you
