cancel
Showing results for 
Search instead for 
Did you mean: 

Initial setup on X440-g2-24p Can't ping between devices with static ip's on ports 2 and 3 (or any others)

Initial setup on X440-g2-24p Can't ping between devices with static ip's on ports 2 and 3 (or any others)

Michael_McNEany
New Contributor
Initial setup, Out of Box configuration... Using the default VLAN, I can't ping between two statically set ips on devices attached to ports 2 and 3. (or any other two ports)
I have:
configure vlan default add ports 1-28
configure vlan default ipaddress 192.168.10.15 255.255.255.0
enable ip forwarding vlan default
configure iproute add default 192.168.10.1
configure bootprelay add 192.168.10.14 vr VR-Default
enable bootprelay ipv4 vlan Default

The devices attached to ports 2 and 3 are windows 7 boxes with ips 10.16 and 10.17. Port 1 is the uplink to another switch.
13 REPLIES 13

Bin
Extreme Employee

Nick_Yakimenko
New Contributor II
what are the IPs of devices connected to port 2 and 3?

"The devices attached to ports 2 and 3 are windows 7 boxes with ips 10.16 and 10.17. Port 1 is the uplink to another switch."

The post was edited with this new information.

Drew_C
Valued Contributor III
Hi Michael,
What version of EXOS is installed on your switch?
Out of the box, be aware of this condition: FN412 - EXOS 21.1.1 Patch 1-2 will not forward traffic with default configuration

The workaround listed there might be what it takes to get you going again.
GTM-P2G8KFN