cancel
Showing results for 
Search instead for 
Did you mean: 

need help For Extreme X450e-48P switch configure UDP data

Mukesh
New Contributor
Extreme Switch X450e-48p help
8 REPLIES 8

Mukesh
New Contributor
anybody can help for passing through multicast traffic on X450e-48pSwitch

Mukesh
New Contributor
Sir can you take my switch online access via teamviewer

EtherMAN
Contributor II
One other consideration since you said this was a CATV headend switch... For mcast to work with IGMP snooping enabled whatever device you have on those ports you want to receive the udp video traffic via multi-cast must know the mcast ip and porrt and make a valid join request. If the switch does not see a valid join then the mcast will not be sent to that port. Unless you have changed the settings igmp snooping is enabled on all vlans by default.

You can do command show igmp snooping detail to confirm this. If you just want to flood all the traffic to those ports then disable igmp snooping and all mcast will be treated as a broadcast frame and the udp stream will be sent to every port you have the vlan on. The device will still need to subscribe to the stream via the ip address and port you are using in the encoders..

Hope this makes sense good luck.

Mukesh
New Contributor
thanks