ExtremeSwitching (Other) - Page 78 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Nestight trap messages shown once “Pse chassis power is in non-redundant state”

Nestight trap messages shown once “Pse chassis power is in non-redundant state” and then recovered back for an A4 switch but the show support logs (logging buffer and current logs ) did not show anything related to this message. Why netsight traps a...

2017-09-04: New GTAC Knowledge Articles August 27 to September 02, 2017

Here are the new articles that were published August 27 - September 02, 2017 in GTAC Knowledge: Sunday, August 27, 2017: Why do EMC Reports for Access Control "Reason" do not match "Statistics" tab in NAC Manager MIB OID for Admin Status Up/Down Mo...

IGMP v1 query received in logs...

Hello, In one of our x450-G2-48t-10G switch getting IGMP v1 query continously from the IP address 192.168.1.1. This query is receiving in one particular vlan. We are using 10.x.x.x IP series for this vlan. We don't know where is the source 192.168...

2017-08-28: New GTAC Knowledge Articles August 20 - 26, 2017

Here are the new articles that were published August 20 - August 26, 2017 in GTAC Knowledge: Sunday, August 20, 2017: none Monday, August 21, 2017: WS-AP3805 Access Point reboot with do_syslog error Imaging Using MulticastFailsIf Routed Sometimes D...

Two X440 stacked random access to management

Hello I'm quite new to Extreme and have yet some limited knowledge about XOS. But the story is that i have replaced our core router (X440-24t) with two "new" X440-24t in stack. Firmware version 16.2.2.4 as Extreme recommends for the X440. I have co...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN