ExtremeSwitching (VSP/Fabric Engine) - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! Do Not Fragment bit in Fabric Engine 'Ping'

HiI want to test MTU between two Fabric Extend endpoints both running 9.0.4 that traverse a third party network where the third party does not always set the path MTU to allow FE (it's usually 1900 end to end).I'm pinging from the tunnel interface on...

Assistance with OSPF config for default route

I need help with VOSS configs to add the default route. Here's the config from a cisco box but need help converting it to VOSS codeCore Switch Configuration# Enable OSPF process 1router ospf 1router-id 1.1.1.1network 192.168.1.0 0.0.0.3 area 0 # Adv...

LACP Key Mismatch Issue Between Extreme 7520 VOSS and HPE 8360 VSX Switches

I am experiencing an issue with LACP key mismatch between my Extreme 7520 VOSS switches and HPE 8360 VSX switches. Here are the details of my setup and the problem:Setup:Extreme Switches: 2 x Extreme 7520 VOSSHPE Switches: 2 x HPE 8360 VSXLACP Config...

show ip dhcp-snooping binding summary is blank

I don't know how to get this command to populate any information. We are using 5320's on VOSS 9.0.3.0. DHCP Snooping says its enabled and the ports all say untrusted. I have clients connected but table is blank. What am I missing? Thanks so much.

Resolved! /31 netmask

hi i am trying to configure a /31 address in VSP 7400 rel 8.6 but always gives error.“brouter port 1/54 vlan XXXX subnet XXX.YYY.ZZZ.153 255.255.255.254” “port 1/54, Invalid IP address” is this possible or not on VSP? thanks in advAntero

Top Kudoed Authors

User

Count

34

18

18

18

8

GTM-P2G8KFN