cancel
Showing results for 
Search instead for 
Did you mean: 

Google Chromecast and AP-7522I

Google Chromecast and AP-7522I

joesatriani
New Contributor

Hi, I have this device and I have a problem with Google Chromecast.

Chromecast connects to wifi but my phone doesn’t find the Chromecast and cast doesn’t work.

Can you help me please?

1 ACCEPTED SOLUTION

Christoph_S
Extreme Employee
  1. Run putty.exe
  2. Select SSH radio button
  3. Enter IP address of AP and click Open
  4. Log into AP and type the following commands

conf t      press enter

WLAN wlan 5      press enter

client-client-communication     press enter

com wr            press enter

OR an easier way for you may be to follow these instructions from GUI:

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-enable-client-to-client-communicati...

 

For the version just type the command: show version

or from GUI go to Configuration » Access Points » You should see the version in the Firmware column. 

Thank you,

 

Chris

Christoph S.

View solution in original post

13 REPLIES 13

joesatriani
New Contributor

Firmware is 

97cedee756cf41c28c3ab7aa50926dce_8e599f0e-12c7-4c9a-b819-4c002880da19.png

 

joesatriani
New Contributor

Ok thank you.

I have this error. I wanted to separate 2.4 and 5 ghz. Is good my configuration?

 

50621e02a02a4dcbb7790fba08b3ee27_930fbf51-596c-4087-879a-b94cffe6032d.png

 

50621e02a02a4dcbb7790fba08b3ee27_5864f296-9d59-47f5-a633-1e5689001a72.png

 

Christoph_S
Extreme Employee
  1. Run putty.exe
  2. Select SSH radio button
  3. Enter IP address of AP and click Open
  4. Log into AP and type the following commands

conf t      press enter

WLAN wlan 5      press enter

client-client-communication     press enter

com wr            press enter

OR an easier way for you may be to follow these instructions from GUI:

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-enable-client-to-client-communicati...

 

For the version just type the command: show version

or from GUI go to Configuration » Access Points » You should see the version in the Firmware column. 

Thank you,

 

Chris

Christoph S.

joesatriani
New Contributor

 

How to remove this? excuse me but I don’t understand.

Can you help me for check the firmware version?

Christoph_S
Extreme Employee

From your output:

Casa#show run wlan 5
wlan 5
 ssid Telecom1567725
 vlan 1
 bridging-mode local
 encryption-type ccmp
 authentication-type none
 no client-client-communication
 no fast-bss-transition over-ds
 wpa-wpa2 psk 0 ----
 use wlan-qos-policy 5

 

Remove this and test:

#conf t

#wlan wlan 5

#client-client-communication

#com wr

#show run wlan 5      

Also make sure you are on the latest firmware. 

Did you implement the best practices firewall policy yet?

Christoph S.
GTM-P2G8KFN