Extreme Networks

Is it possible to set the auto-sense data I-SID for a port using XIQ? If I have a port set to auto-sense and manually set this config on the portauto-sense data i-sid 10010010then XIQ complains about the config not matching. But there's no way to do ...

Is there a way to stop pmksa_cache_auth_add messages filling up the AP logs? I'm trying to debug an issue and there's only 30 seconds of logs shown by show log buffered.

I found the client health dashboard has a breakdown of 2.4/5/6GHz clients, but is it possible to get that breakdown over time? And still filter by location, or even better, graph each building's breakdown.

Are there any statistics exposed for an MLT, or only its component interfaces? The MLT exists under ENTITY-MIB but nowhere else that I can find with an snmpwalk:SNMPv2-SMI::mib-2.47.1.2.1.1.2.6290 = STRING: "MLT- mizar-d LAG1"SNMPv2-SMI::mib-2.47.1.2...

I have an SSID that I want advertised only on 2.4GHz in most locations, but 5GHz as well in some areas. I looked at a classification rule, but that only does the AP, not the radio. I know I could go and turn the SSID off on each AP I didn't want it o...