Extreme Networks

There is two part of the question here.As I asked before, if it was possible to use an ordinary USB flash drive.  I couldn't get it to work.  I formatted it FAT32 with a partition under 2GB.  sw0# usb onTrying to enable USB device. Please wait...Fail...

all of the sudden the VDX6740 just "crashed"... and it restarted itself... but after reload itself.  All the license was intact.  However, all my config is gone.So my question is, is there a way to backup the config to an external source so if this h...

I need to bond two links from an AP, the AP only support SRC MAC+DST MAC, DST MAC, and SRC MAC. I didn't see one that match in the manual....What load balance should I pick?  I wasn't sure on the description because they all say "and".  In that conte...

Is there anyway to emulate NOS to use in GNS3?  or is there anything that I can learn the commands in GNS3 that is similar to NOS?

Once again I am confused with the context between rbridge and interface to assign an ip address.If I wanted to connect a port, TE 1/0/24 to an internet firewall/router.  Which one is the correct context to ? #conf#int te 1/0/24#no switchport#ip addre...