cluster config update rejected

  • 0
  • 2
  • Problem
  • Updated 6 months ago
  • Solved
Hello
I have a cluster with 2 rfs 6000. Since yesterday, this event appears:
Err: cluster config update rejected - master does not accept full config.
And any configuration made in the active rfs is not replicated in the standby rfs
Photo of Jose_LV

Jose_LV

  • 1,224 Points 1k badge 2x thumb

Posted 7 months ago

  • 0
  • 2
Photo of Andy Holden

Andy Holden, Employee

  • 1,472 Points 1k badge 2x thumb

Please check how your CLUSTER was formed. Are you forming it with both I/P and VLAN. If so, remove the CLUSTER VLAN.

If not the issue, you will need to submit a case .

Photo of Jose_LV

Jose_LV

  • 1,224 Points 1k badge 2x thumb
Hello Andy
Thanks for the reply.
The cluster was already formed. And the vlan cluster is already disabled.
Photo of Daniel Mejia

Daniel Mejia, Employee

  • 1,056 Points 1k badge 2x thumb
Hi Jose,

Please reference the following KCS article on WiNG cluster configuration.

How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above
Photo of Timo

Timo

  • 3,210 Points 3k badge 2x thumb
Hi,
do you have configured different priority? If you don't configure this and have new configuration on booth sides, that can be the problem. 
Photo of Jose_LV

Jose_LV

  • 1,224 Points 1k badge 2x thumb
Hi Timo
The priorities are configured with different values in the two rfs.
The rfs and the cluster were working well for a long time until the restart that was made yesterday.

the show cluster member command shows the two rfs and the show cluster status command shows one rfs in active and another in stanby in the cluster
Photo of Jose_LV

Jose_LV

  • 1,224 Points 1k badge 2x thumb
Solved
Turning off and starting the controllers in order, first the active controller and then the standby controller, the cluster has been configured ok and the error has disappeared. The simplest solution at the end is the most effective.
Thanks everyone
Regards.