Hello folks, I am configuring 802.1x on X450-G2 switch and I while trying to configure guest access I realized, that the commands I found in KB and in documentation are simply not there. I am talking about these commands:configure netlogin dot1x gues...
We have 3 sites that deploy 2 x460 at each site in a stack. The sites are connected to each other via a shared interface of two ports on each siteSite A Port 25, Port 26 --> Site B Port 27, Port 28Site B Port 25, Port 26 --> Site C Port 27, Port 28Si...
Is it possible to mix stacking method when I stack 2 switches 5520 (without VIM-4X) and 2 switches 5420 series switches using U1 and U2 port , using QSFT+ to QSFP+ cable between 5520 (SummitStack-V160) and special cable which converts QSFP+ to SFP-DD...
hi, I'd like to know which is the best method to stack 2 switch 5520 24p fiber with VIM-4XE installed and 2 switch 5420 48p. Is it possible to stack using SFP+ module installed in VIM-4XE module, or I should use stacking port U1 and U2 with proper ca...
I have brought several Extreme switches from a recycling center and I am setting them up for use on my home network. While I have reset them to the point I can log in to them I have noticed one of them, a X435-8P-4S, is showing the message "Warning:...
