Resolved! Any recommendations for a wall mount rack for the Summit x450 g2 switch?
Open to recommendations for racks for the x450 g2 switch. Haven't found a good brand.
Open to recommendations for racks for the x450 g2 switch. Haven't found a good brand.
How to redundantly connect two layer 2 networks (each with redundancy/loops) such that topology (changes) of one does not affect topology of the other?Here is such a design, however the requirement for this to work is that the orange VLAN must NOT be...
Hello,I wish to connect a device on a vlan but somehow it's traffic is filtered and I can't reach it.This devices only seems to use ARP, it doesn't answer to pings. Moreover, it uses a multicast MAC address.I have tried using a simpler switch and it ...
I'm new to Extreme, how do you show unused ports on each module/stack. I have tried many of the "show ports commands, but it's not want I'm looking for, thank you.
Hello guys!I'm in a scenario (in the attached draw) with 7 switches, where 2 of them are cores X460, and the 5 others are edges X440. We have EAPS configured with 5 Control VLANs and one VoIP VLAN. When the uplinks between Core 1 and Core 2 (2 red ca...