I have a customer with 700 aps on a campus, and when the customer move from one building to other and lose the conection with ap and when move to another build reconnect, and stop the traffic... Its necessary manually reconect.
The time between move from one site to another is 2,3 minutes and connection is lost. ANy idea??
The Inter-wlan is enabled..
are specific clients affected or almost all wireless clients.
If roaming between Aps which is connected on different Controller then to configure Mobility should get some improvement.
What FW Version on AP Types has this issue?
If Radius enabled try different key caching settings..like OKC or pre-auth
Are the wireless users dropped onto the same subnet when they go from building A to building B ? If you use the same subnet then it should work. Is the problem that when the client goes from building A to B, that they have to hit a portal page and enter their username / password again?
Probably don't need mobility enabled, could use availability instead, since you only have 2 controlers. Mobility is if you have more than 2 controllers, or if you are using routed topologies. In your case you have 2 controllers and you are using bridge at controller.
Are you using nac?
inter-area - you can draw the Area on the OneView map. When the client enters there it will send VSA back to NAC, so different Role can be applied.
Default setting is none by the way for mac-based authorization on roam. You would enalble for the visibility.
Topology groups might help you in this situation.
You could create many bridge at controller topologies. Then make one group out of them. Your student vns could use the topology group as the topology. Then the users would be assigned to one of the topologies in the group based on the last 4 digits of their mac address. That way, a student would keep his ip address regardless of which building they were in.