Anyone else having issues with the AP650 rebooting on firmware 10.0r8?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2020 01:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-09-2020 01:06 PM
I have enabled this on a few APs, we will see if this changes the behavior, thanks for the recommendation.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2020 06:32 PM
Have you tried poe-allocate-by class at the switch port?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2020 06:17 PM
The interesting thing about this is. The AP reports full AT power. The switch port reports it is delivering power correctly. If you review the switch logs however you are presented with an error stating the PD requested too much power and the port is being shut down. The switches have plenty of power available at this time. Packet captures show LLDP packets coming back from the switch that appear to show delivery is broken.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2020 06:15 PM
Check PoE status on AP by running show system power status.
Check power delivered on switchport.
