I recently updated an AP130 from 6.5r4 to 6.5r11 and I noticed it didn't come back online. The reset button does nothing. I connected to it with a serial cable and this is what I get:
U-Boot 2012.10 (Nov 01 2016 - 04:29:54)
I2C: ready
Wait.
Done.
DEV ID= 0000cf12
REV ID= 00000000
SKU ID = 2
OTP status: eca01028
MEMC 0 DDR speed = 533MHz
Log: ddr40_phy_init.c: Configuring DDR Controller PLLs
Log: offset = 0x18010800
Log: VCO_FREQ is 1066 which is greater than 1Ghz.
Log: DDR Phy PLL polling for lock
Log: DDR Phy PLL locked.
Log: ddr40_phy_init::DDR PHY step size calibration complete.
Log: ddr40_phy_init:: Virtual VttSetup onm CONNECT=0x01CF7FFF, OVERRIDE=0x00077FFF
Log: ddr40_phy_init:: Virtual Vtt Enabled
Log: DDR Controller PLL Configuration Complete
PHY register dump after DDR PHY init
PHY register dump after mode register write
DRAM: 256 MiB
WARNING: Caches not enabled
GPIO Init ... Done
NAND: NAND_FLASH_DEVICE_ID_ADDR = 18028194
Done that
(ONFI), S34ML04G1, blocks per lun: 1000 lun count: 1
*ERROR* Invalid strap options for this NAND: page=1 type=2
Overriding invalid strap options: strap_type=2
128 KiB blocks, 2 KiB pages, 16B OOB, 8-bit
NAND: chipsize
total 1 bad blocks,LIST:
00200000
now the up level will see a good flash chip no bad block which size is 1ffe0000
before nvram partition, there are 1 bad blocks
511 MiB
Using default environment
In: serial
Out: serial
Err: serial
Unlocking L2 Cache ...Done
arm_clk=800MHz, axi_clk=400MHz, apb_clk=200MHz, arm_periph_clk=400MHz
Net: Registering eth
Broadcom BCM IPROC Ethernet driver 0.1
Using GMAC1 (0x18025000)
et0: ethHw_chipAttach: Chip ID: 0xcf12; phyaddr: 0x1e
bcm_robo_attach: devid: 0x53011
bcmiproc_eth-0
MAC address is 885b:dd6c:b780
NVRAM_MAGIC found at offset 440000
