cancel
Showing results for 
Search instead for 
Did you mean: 

AP550's are running in AF power mode.

AP550's are running in AF power mode.

adam_clegg
New Contributor III
AP550's are running in AF power mode.
1 ACCEPTED SOLUTION

adam_clegg
New Contributor III

I was able to get AT power running on the AP550's by using the following command:

 

"no lldp config <port#> dot3TlvEnable poeplus_config" as of right now it is stable.

 

This is were I found the information:

 

https://www.reddit.com/r/networking/comments/4dl6rv/hp_2530_2448_port_poe_not_delivering_poe/

 

This essentially disables LLDP PoE+ negotiations and the AP will detect 802.3at power during initial PoE negotiation vs doing it via LLDP. I don't feel this is a complete solution as I want LLDP to work. I will continue to work with HP to figure out why this command is needed.

 

Thank you,

View solution in original post

23 REPLIES 23

JA
New Contributor III

Hi Adam

Did you ever get a resolution for this from HP?

Thanks

J

adam_clegg
New Contributor III

I was able to get AT power running on the AP550's by using the following command:

 

"no lldp config <port#> dot3TlvEnable poeplus_config" as of right now it is stable.

 

This is were I found the information:

 

https://www.reddit.com/r/networking/comments/4dl6rv/hp_2530_2448_port_poe_not_delivering_poe/

 

This essentially disables LLDP PoE+ negotiations and the AP will detect 802.3at power during initial PoE negotiation vs doing it via LLDP. I don't feel this is a complete solution as I want LLDP to work. I will continue to work with HP to figure out why this command is needed.

 

Thank you,

AnonymousM
Valued Contributor II

Here is lldp neighbor returned from an AP250. It is plugged into an Aerohive SR2208 switch:

 

> show lldp nei 

============================

LLDP neighbor table: Total number = 1

--------------------------------

Incoming Port: eth0

Chassis ID(mac address): b87c:f201:0290

Port ID(interface name): 1/0/2

Hold time(seconds): 110

System name: BP-SR2208P

802.3 Power Via MDI:

MDI Power Support: 0x0f

Port Class: PSE

PSE MDI power: supported

PSE MDI power enabled: yes

PSE pairs control ability: yes

PSE power pair: signal pair

power class: class 4

power type: type 2 PSE

power source: primary power source

power priority: low

PD requested power: 154

 PSE allocated power: 154

802.3 MAC/PHY status:

auto-negotiation support/status: 0x03

auto-negotiation: supported

auto-negotiation: enabled

PMD auto-negotiation: 0x1

Bit on: 1000BASE-T full duplex

MAU: Unknown type(0)

TIA - Media Capabilities:

Capabilities: 0xb

LLDP-MED capabilities

network policy

extended power via MDI - PSE

Device Type: Network Connectivity

 

On a Ruckus ICX-7150-C12P, I simply did the command "lldp run" to enable it globally on my switch stack. On the Aerohive switch I also just enabled it without any extra configuration.

adam_clegg
New Contributor III

Brian,

 

Two questions:

  1. When using the command "show lldp neighbor" what should the results be?
  2. On your Ruckus switch could you tell me what you lldp settings are?

 

Thank you,

GTM-P2G8KFN