Extreme Networks

AnonymousM · ‎08-20-2019

Can please someone provide the commands needed to configure Secure Port Settings via Supplemental CLI in Hivemanager NG?

s_heise · ‎10-23-2019

Probably our support got a feedback from Aerohive with the commands that where already mentioned in this feed.

I got the information that you will be unable to enter a password for the supplicant, but with the right firmware it is possible.

For AP141 it doesn't work as the commands doesn't exist there and also the configuration isn't supported as it is done by CLI only.

@Sam Pirok is it possible that you start a feature request for this, as it was already possible to configure it on the Hivemanager Classic Cloud GUI, so this configuration will be supported again?

View solution in original post

AnonymousM · ‎08-20-2019

Hi Sam,

as the option is no longer available in Hivemanager NG as far as I know.

In Hivemanager Classic this option was at:

Network Policy --> Additional Settings

At Hivemanager NG I haven't found it.

Best regards,

Sebastian Heise

samantha_lynn · ‎08-20-2019

That would be quite a few commands, and CLI configuration isn't supported. Can I ask why you aren't using the GUI to implement these settings?