I have switches and APs that are not responding to SNMP gets. Below is the SNMP config found in the switch running-config. I've verified the community string, host IP address, and that the network is wide open between the host and the switch. Any ide

[jhawbaker]

I have switches and APs that are not responding to SNMP gets. Below is the SNMP config found in the switch running-config. I've verified the community string, host IP address, and that the network is wide open between the host and the switch. Any ide

[dparsons]

Those are not the settings you need to do an SNMP get. There should be a string such as this in the configuration:

snmp-server community "fake-string" r

On my switches there is an rw community string. And if you just set this up then there is a chance HiveManager changed it. Each switch now has a unique rw string after the last update.

[jhawbaker]

From the switch running-config:

snmp trap-info over-snmp

snmp trap-host v2c x.x.x.x community fakestring

snmp reader version v2c community fakestring x.x.x.x