Ironware secondary image was not upgraded on the Line cards on MLX-4
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-20-2020 03:45 PM
Hello,
I was able to successfully upgrade an MLX-4 to version 6.2.00d.Yet , when i issue the show flash command , the S1 through S4 show that the primary Ironware was upgraded to 6.2.00d , however the secondary image did not get upgraded to 6.2.00d
o IronWare Image (Primary)
Version 6.2.0dT177, Size 9571326 bytes, Check Sum fc39
Compiled on Jun 6 2019 at 01:50:00 labeled as xmlp06200d
o IronWare Image (Secondary)
Version 5.9.0T177, Size 9485930 bytes, Check Sum 880f
Compiled on Feb 24 2016 at 07:27:20 labeled as xmlp05900b1
this is the command i used to perform the upgrade
copy tftp system all-images x.x.x.x manifest MLX06200d_Manifest.txt
Please advise
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-20-2020 03:58 PM
Thank you kindly for your prompt response to my inquiry.
I will go head and perform the action you recommended
Thank you again
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-20-2020 03:55 PM
copy tftp flash x.x.x.x xmr06200d.bin secondary
copy tftp lp x.x.x.x xmlp06200d.bin secondary all