Confirm how to configure logical-chassis mode
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-28-2021 09:36 PM
Hi I'd like to confirm the correct command to configure a VDX6740 firmware 7.2.0c.
I read in some older doco switch# vcs vcsid 1 rbridge-id 2 logical-chassis enable but this is not available and I can't recall the correct syntax and mode to execute this.
Thank you.
I read in some older doco switch# vcs vcsid 1 rbridge-id 2 logical-chassis enable but this is not available and I can't recall the correct syntax and mode to execute this.
Thank you.
7 REPLIES 7
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-29-2021 12:55 AM
Hi Russ,
Starting NOS 7.1.x and higher, the only valid VCS mode is logical chassis which is enabled by default, so there's no need to configure logical-chassis enable anymore. You just need to set the VCS ID and RB ID.
Starting NOS 7.1.x and higher, the only valid VCS mode is logical chassis which is enabled by default, so there's no need to configure logical-chassis enable anymore. You just need to set the VCS ID and RB ID.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-29-2021 01:04 AM
Hi thanks for you reply. When I was checking the status after applying the VCSID and RB ID the output indicated that the switch was in VCS Mode : Fabric Cluster and not logical-chassis.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-29-2021 01:13 AM
You will need to downgrade to 7.0.x, then set the vcs mode to logical chassis, then upgrade.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-29-2021 06:49 PM
Thanks again, for reference what was the command to configure logical-chassis mode?
