AP330 Boot Loop (Ethernet 1)

[JayS]

Good day.

I have a few AP330. I have one that is doing something really weird. When I use the console port it boots fine and I can assess the device. When I plug an ethernet cable into either Ethernet 0 or 1, the device goes into a boot loop. I have reset to default settings and it still loops continuously. If I restart the device with no ethernet again, it boots normally.

Please assist.

[SamPirok]

Hi Jay, thanks for reaching out. Apologies for the slow response here, I was out all last week. Could you tell me what firmware the AP 330's are using? Does the boot loop start immediately when you connect the Ethernet cable? You mentioned you have a few APs, just to confirm, it's just one of those APs that is having this issue? When you plug the same cable in to a different AP, do you get the same behavior?