How to bind a Custom FlexView in to Oneview Device View

[_up__bb_]

Hi,
I created my custom FlexView, now I would like to apply this flexview to a specific device,
so I can see the information about these flex on the Device View of the OneView.
How I can set up this binding?

Thanks
Roberto

[_up__bb_]

I need to create a FlexView for a specific device type (1 flex view for Motorola NX Wireless Controller and 1 flex view for MOXA Industrial Switches) and let to view the info of the respective flexview when I click on the Device View of the OneView.
I have tried but something goes wrong.

So If you have a guide step by steb or how-to is the best, or if you provide me your example I can try to catch where I'm wrong ...

Thanks
Roberto

[Mike_Thomas]

Hi Roberto, are you asking about how viewed my Flexview as you see it, or about my custom fleview itself? Can you clarify? I think your asking about the flexview itself.

[_up__bb_]

Hi Thomas,

how you have linked the flexview to the switch L1-L2-10.58.1.24?
With an oid snmp that match the device type or with some name?
And where you have wroten them?
Can you share an exmple?

Thanks
Roberto

[Mike_Thomas]

Hello Roberto. I was able to add in a custom flexview by taking what I have previously made and dropping it into the NetSight\appdata\System\FlexViews\My FlexViews folder on my server.
Then I stopped and started the server again and it shows up.

[Mike_Thomas]

Matthias, I sent it to you via email as a zip file. In the past, these .tpl files even zipped are not liked by email filters. So hopefully it gets there for you. Some of the MIBs are likely not valuable across several platforms FYI. So it stands as it is. Of course you can add or subtract information as you see fit as well and make your own. I have used in the past for preliminary network health checks (at L1-L2 layer of course).