Non-stop rebooting, bad address in epc, kernel panic
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-02-2017 10:42 AM
summit x350-24t, constantly rebooting.
From console (manually rewrite general lines):
- code: (bad address in epc);
- fatal exception: panic in 5 seconds
- kernel panic - not syncing: fatal exception;
- reboot
In Bootstrap, Test memory with command 'mt', result:
-1 test itterations passed with no errors.
Is switch dead? What I can do?
I'm not previously debug extreme switches...
From console (manually rewrite general lines):
- code: (bad address in epc);
- fatal exception: panic in 5 seconds
- kernel panic - not syncing: fatal exception;
- reboot
In Bootstrap, Test memory with command 'mt', result:
-1 test itterations passed with no errors.
Is switch dead? What I can do?
I'm not previously debug extreme switches...
16 REPLIES 16
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-05-2017 10:58 AM
memory test was successful - test itterations passed with no errors.
baddly, but no one of these "loader 1 or 2 - boot 1 or 2" commands unable get out of non-stop rebooting switch.
For now, for me - it is dead 
baddly, but no one of these "loader 1 or 2 - boot 1 or 2" commands unable get out of non-stop rebooting switch.
For now, for me - it is dead 
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-05-2017 10:16 AM
I successfully download image "summitX-12.6.2.10-patch1-15.xos" - file from last/only my summit upgrade.
.... then standard process... installing 12.6.2.10... clearing vnram .... press ENTER to reboot...
AND after restart
"kernet panic" like bottom in this topic 😞
Is this the end of the day for this switch?
.... then standard process... installing 12.6.2.10... clearing vnram .... press ENTER to reboot...
AND after restart
"kernet panic" like bottom in this topic 😞
Is this the end of the day for this switch?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-05-2017 08:55 AM
Management port Ethernet is used for ... management like tftp
try to ping first
try to ping first
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-05-2017 08:53 AM
Try 192.168.1.155/24 and not 192.168.1.155/255.255.255.0
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-05-2017 08:53 AM
informative - I try both method and both of them is working,
My mistake was on cable/VLAN outside summit and it not depend from input IP/mask form....
My mistake was on cable/VLAN outside summit and it not depend from input IP/mask form....
