Oneview/Purview application response times missing

[mp2014]

Hi,

i see no network or applications response times in Purview/Oneview, what to check in my configuration?

[mp2014]

ah nice script 🙂

My setup looks ok:
--------------------------------------------------
Process appid is running at pid 1662
Process appidserver is running at pid 1027
--------------------------------------------------
Checking for traffic on interface gre1
Checking for Netflow records on interface eth0..
Checking for IPFIX records on loopback interface..
--------------------------------------------------
Waiting for captures to complete..
Mirror appears to be setup correctly on gre1.
IPFIX appears to be setup correctly.
Netflow appears to be setup correctly on eth0.
--------------------------------------------------

[Rex_Kong]

I also experienced the same issue. After changing the VM port group VLAN ID from 0(default) to 4095, I could see the network and application response time.

[mp2014]

ok thanks for sharing, I guess the vlan issue shouldnt apply in my case because the mirrored data leaves the gre tunnel within the VM. Or maybe I need to check vlan id handling within the data leaving the gre tunnel.

[Rex_Kong]

The purview deployment mode was in overlay mode with a purview engine(virtual appliance) of 2 interfaces, i.e. eth0 for management, eth1 for monitoring mirrored netflow traffic from a purview sensor(CoreFlow2 switch). I changed the VM port group(eth1) VLAN ID from 0 to 4095.

[mp2014]

what purview deployment mode you run? i use "single interface" for management + the gre tunnel for mirroring. If i change the vlan id management will be affected