Background Scans and DFS
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
02-04-2022 09:48 AM
Hi
I was wondering if anyone had heard if there is an ETA on a fix for the issue where background scans aren't performed if the radio is on a DFS channel?
Thanks
I was wondering if anyone had heard if there is an ETA on a fix for the issue where background scans aren't performed if the radio is on a DFS channel?
Thanks
17 REPLIES 17
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-12-2022 11:12 AM
FYI
In limited testing I have updated an AP130 and 2 AP230s to 10.4r5 on APs that were using DFS channels.
When I ran a sho acsp nei on these APs before the update nothing would show for 5GHz.
After the update the same command shows results on the 5GHz.
In limited testing I have updated an AP130 and 2 AP230s to 10.4r5 on APs that were using DFS channels.
When I ran a sho acsp nei on these APs before the update nothing would show for 5GHz.
After the update the same command shows results on the 5GHz.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-16-2022 01:24 PM
@w1f1n00b For now it will only be supported on the following ZERO DFS capable APs starting in IQEngine 10.4r5: AP250, AP650/AP510, AP410C's wifi1. Other models are still under review. I would recommend following up with your SE or account rep for roadmap questions.
To your earlier question, this is a design change, not correction of an issue.
To your earlier question, this is a design change, not correction of an issue.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-16-2022 09:27 AM
@Nick Moore, any word if this functionality will extend to older 2 radio APs once 10.4r5 is available?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
03-01-2022 09:01 AM
Thanks Nick
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
02-28-2022 10:53 AM
I've never seen this officially discussed. I did go down the long rabbit trail of trying to figure this out, and was eventually told this was not something to be fixed, but was instead simply how the APs/software were designed.
I was also told this would never be possible for the APs that don't have a 3rd radio.
I'm very curious if the 10.4.5 firmware will bring this functionality to 2 radio aps (ap250,550, etc.)
I was also told this would never be possible for the APs that don't have a 3rd radio.
I'm very curious if the 10.4.5 firmware will bring this functionality to 2 radio aps (ap250,550, etc.)
