cancel
Showing results for 
Search instead for 
Did you mean: 

Delta Update fails

Delta Update fails

Lukas_Manus
New Contributor

Hello,

 

I am trying to push a modified Network Configuration to my APs. The Update starts up, but fails after a few seconds. If I hover over “Device Update failed.” I get the cut off message “The CLI ‘security mac-filter”. Is there any way to show me a detailed log with a full error message?

 

My attempt was to disable the SSID I want to push to the APs because it uses Mac-Authentication. But it didn’t solve my issue.

 

Best regards,

Lukas

1 ACCEPTED SOLUTION

systemscsn
Valued Contributor
Click on the Audit icon next to the AP you are pushing the Delta update too:

03f1fdb927ae43da9e47293b56a65345.png

Then click on the Delta Tab, and it will show the full error message:

cf17d285c22643409004288f6bde9df1.png
Post the full error here, and maybe that will help figure out the issue.

Jason.

View solution in original post

2 REPLIES 2

Lukas_Manus
New Contributor
Hello Jason,

it seems like the problem solved itself in the meantime. Thanks for your reply anyways 🙂

systemscsn
Valued Contributor
Click on the Audit icon next to the AP you are pushing the Delta update too:

03f1fdb927ae43da9e47293b56a65345.png

Then click on the Delta Tab, and it will show the full error message:

cf17d285c22643409004288f6bde9df1.png
Post the full error here, and maybe that will help figure out the issue.

Jason.
GTM-P2G8KFN