ā11-20-2020 05:28 AM
Hello,
I am pulling my hair trying to setup an Aerohive SR2348P switch with a non-default VLAN management. I have done all of the following in various combination with no luck whatsoever.
Results:
If I reset the switch vlan1 will get an IP assigned from DHCP in a heartbeat. Issue is only when I try to change the DHCP.
Also, I could not find any vrf commands in the reference guide. I think the management networks is in its own routing table but not certain about this. Not sure if the ip assigned and verified with the network command is the same used by hivemanager.
Please help.
Solved! Go to Solution.
ā01-06-2021 12:27 PM
Hello, my apologies for the long wait here, thank you for providing all of those details. Iāve reviewed this with our engineers and they requested we get a case open if you havenāt already. Weāll want to look in to specifics for your configuration and itās best if we can keep all that information in a case. Please let me know if you have any further questions and thank you for your patience while we looked in to this for you.
ā01-06-2021 12:27 PM
Hello, my apologies for the long wait here, thank you for providing all of those details. Iāve reviewed this with our engineers and they requested we get a case open if you havenāt already. Weāll want to look in to specifics for your configuration and itās best if we can keep all that information in a case. Please let me know if you have any further questions and thank you for your patience while we looked in to this for you.