Hello. I changed CR battery and update firmware on B2G124-24.
But i have cyclic reboot my switch and this message
sysconf_attach: bcm device init failed
soc_init: unit 2 not attached
system_init: Device reset failed: Invalid unit
In hpcBroadInit:1008, could not find the board
and sometimes have access to Unit 1> console, but i don't input commands because i have error
^ marker error)
--------------Unit cosole is :
Adding 59987 symbols for standalone.
SOC unit 0 attached to PCI device BCM5670_A1
SOC unit 1 attached to PCI device BCM5697_B0
In hpcBroadInit:990, could not find the board
Adding BCM transport pointers
Configuring CPUTRANS TX
Configuring CPUTRANS RX
st_state(0) = 0x0
TOPOLOGY ERROR: Unknown board
TOPO board prg: Board programming failed: Entry not found
TOPO SETUP: Failed topo brd program: Entry not found
ST: Could not setup local topology: Entry not found
TOPOLOGY ERROR: Unknown board
TOPO board prg: Board programming failed: Entry not found
TOPO PKT ERROR: appl fail: Entry not found
st_state(1) = 0x4
st_state(2) = 0x4
st_state(3) = 0x4
st_state(4) = 0x4
st_state(5) = 0x4
st_state(6) = 0x4
st_state(7) = 0x4
st_state(8) = 0x4
st_state(9) = 0x4
st_state(10) = 0x4
st_state(11) = 0x4
st_state(12) = 0x4
st_state(13) = 0x4
st_state(14) = 0x4
st_state(15) = 0x4
st_state(16) = 0x4
st_state(17) = 0x4
st_state(18) = 0x4
st_state(19) = 0x4
st_state(20) = 0x4
st_state(21) = 0x4
st_state(22) = 0x4
st_state(23) = 0x4
st_state(24) = 0x4
st_state(25) = 0x4
st_state(26) = 0x4
st_state(27) = 0x4
st_state(28) = 0x4
st_state(29) = 0x4
st_state(30) = 0x4
TKS ST TIMEOUT in state TOPO
Please help me
Sorry for my English
