VoIP phone causing Loop - Disable port with Duplicate MAC Address
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2016 05:27 PM
Customer has VoIP Phones. Users will plug both ports into wall jacks causing a loop. Looking for solution
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2016 05:31 PM
Hello Bill
Can you please tell me what switch you are using? If it is one that runs XOS as the operating system then you can use a feature called ELRP. It works similar to STP but it is not as configuration detailed. It is essentially two commands.
If it is EOS based or if there is a mixture then STP is a better fit.
Let us know
Thanks
P
Can you please tell me what switch you are using? If it is one that runs XOS as the operating system then you can use a feature called ELRP. It works similar to STP but it is not as configuration detailed. It is essentially two commands.
If it is EOS based or if there is a mixture then STP is a better fit.
Let us know
Thanks
P
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2016 05:31 PM
computer goes into phone, phone goes into wall
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2016 05:30 PM
Configure STP on the edge ports with BPDUSafeguard enabled.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2016 05:30 PM
only plug one jack in