04-18-2024 01:55 PM
Does anyone have good information about CoA using XMC against ERS switches? If I press "Force Reauthentication" through XMC Control, should I expect the port to bounce? I personally don't see anything happening so looking for some guidance.
Also, after an ERS transitions from Fail Open mode to regular mode, is there a way to force the switch to bounce all the ports using RADIUS attributes as part of re-authentication?
07-23-2024 03:52 AM
Hi,
XIQ-SE/XMC can send CoA to ERS but the port will not bouce.
The switch will change the EAP status of the port and reauthenticate the device. I used this successfully.
You'll have to add the correct config into the ERS switch for CoA.
Use this as CoA profile in the advanced window of Control:
Some times you'll have to add the correct OID in the global default engine settings like this:
Mig