24 port EXOS VM in GNS3/QEMU

[Ash]

Hi,

I was able to successfully create a QEMU EXOS VM and console into it. Strangely though, when I create the QEMU VM, i choose 24 ports in e1000 type adapter however when i issue the 'show ports' command in EXOS, it only shows 12 ports. Is this limitation built into EXOS or QEMU?

Anyone has any experience in this setup? Is there a way to overcome this limitation?

Thanks

[Marcin_Kuczera]

by the way, what's is the most recent EXOS release in VM environment ?
I need something paralel to 15.7 or higher

[Drew_C]

Check our GitHub page - https://github.com/extremenetworks/Virtual_EXOS
EXOS 16.1.2.14 is posted there. v16.1.3 should be arriving soon and I'll post it there too.

[Ash]

even on my qemu VM, i'm able to configure 32 ports, but when i start up the EXOS VM, it only recognizes 12. I'm determining that its recognizing only 12 because show port command only shows 12.

[Stephane_Grosj1]

After asking around, it looks like this limit may more be of an Hypervisor limit than vEXOS. Looks like some were able to have 32 ports on VM (qemu). It may vary with the version.

[Ash]

Grosjean, Stephane,

Here's the config for my qemu. Please check if possible to see if I've mis configured something.