cancel
Showing results for 
Search instead for 
Did you mean: 

Direct VLAN traffic to 2 different firewalls

Direct VLAN traffic to 2 different firewalls

CHRLX-ENG
New Contributor

We are setting up 2 firewalls for internet access via 2 individual circuits.  Currently our default route sends all traffic to firewall #1.  We are looking to send all traffic from a single VLAN to the new firewall (firewall #2) and all other VLANS to firewall #1.  How do I set up a routing configuration for this?

1 ACCEPTED SOLUTION

Stefan_K_
Valued Contributor

The BlackDiamond is the router (the VLAN-Interfaces are on the BlackDiamond?) and routes the traffic to the firewalls?

In this case you could use different VRs or use flow-redirect IMO.

View solution in original post

6 REPLIES 6

Stefan_K_
Valued Contributor

If you use different VRs you don’t need flow-redirect. You can simply create two default-routes, one for each VR.

CHRLX-ENG
New Contributor

This is correct Stephan K.  I will look into flow-redirect with different VRs.  Thank you.

Stefan_K_
Valued Contributor

The BlackDiamond is the router (the VLAN-Interfaces are on the BlackDiamond?) and routes the traffic to the firewalls?

In this case you could use different VRs or use flow-redirect IMO.

CHRLX-ENG
New Contributor
6e4ad56e159c44d0b6e4b66854c37ba2_b45cd9e2-46af-4b27-bd67-5daf728458ab.jpg

Here is the basic network topology that we have with the new firewall addition

GTM-P2G8KFN