Error: System cannot support Load Sharing among port media types with different maximum speed

[Keith9]

Trying to pre-stage a 2 switch stack (5520).  They both have 4 port nims in the side.  When it goes to its destination SFP+ ports will be plugged in and uplinked to an existing connection (migrating from a Cisco stack).

I am getting this message when trying these commands:
enable sharing 1:57 grouping 1:57-2:57 algorithm address-based L3_L4 lacp

Error: System cannot support Load Sharing among port media types with different maximum speed

Do I have to have the SFP+ trancievers installed first?  I just wanted to get the configuration on there so at the site it can be plug and play.

[Keith9 · Accepted solution]

Oh shoot I mistyped i had a dash not a comma.

This is the correct command

enable sharing 1:57 grouping 1:57,2:57 algorithm address-based L3_L4 lacp

But yes I IM’d someone on site and they inserted SFP+ for me.  I realized that still didnt work and then saw I had the dash instead of comma.