Extreme x620-16t Inventory manager archive error "Connection Refused" CLI access is not enabled
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-09-2017 03:50 PM
I have 2 x620-16t switches that my coworker has setup. The 2nd switch was setup using the config from the first one and had the IP changed so the config should be the same. However, I am not able to get the archive working in EMC/Inventory Mgr. It gives the error "Connection refused, CLI access is not enabled for this device". I got the first one working but this one will not. How to I enable this when all settings that I know of are or should be the same as the first switch?
17 REPLIES 17
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-15-2021 06:26 PM
Disable and enable ssh ?
Old topic but I ran into this issue today on an X460-G2 switch. This solved the problem for me.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-24-2017 01:00 PM
Well, it turns out that there was a bug for SSH in the firmware version that came on the switches. The latest that came out on February 1st is supposed to fix it and I will be applying that to both switches today and retesting.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-09-2017 09:08 PM
Remove the switch and re-add it. If that's possible...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-09-2017 04:04 PM
Disable and enable ssh ?
Regards
Zdeněk Pala
